Horizontal ProfileMatic Contour Cutter

• Great for cutting intricate designs in urethane foams both flexible and rigid as well as most grades of Ethafoam, Foamglas, mineral wool, EPS, and similar materials
• Makes cutting pipe insulation sections easy

Click here for more information

Dual Head ProfileMatic Contour Cutter

• Two sizes of machine to choose from
• Great for cutting intricate designs in urethane foams both flexible and rigid as well as most grades of Ethafoam, Foamglas, mineral wool, EPS, and similar materials
• Cuts contours both vertically and horizontally

Click here for more information

 

HT-51-88-PVT Horizontal Slitter

• Fully loaded with vacuum table and airlift
• High-tension (HT) head should be used for higher density materials such as rebonded foam, latex and visco-elastic flexible materials up to 6lb/ft3 (96kg/m3)

Click here for more information

 

MBOCA Stand Alone Solid Curative Melter

Five gallon working capacity, non-painted stainless steel tank with inverted cone melter supported by a hot oil closed loop recirculation system with independent electronic controller which also supports the MOCA dispenser.

System is capable of Moca melt rate of 2.5 lbs./min. based on 9 KW using 280 degree F oil.

A regenerative blower and hosing is provided to vacuum transfer Moca pellets from fiber drum to melter with exhaust diverted back to fiber drum to minimize dust released. Blower is interfaced with melt tank level controls to maintain a minimum constant melt level to prevent heat degradation.

M-100 Low Pressure Mix Head

Our smallest dynamic mix head produced with external valving for recirculation. Utilized for gasketing applications.

Click here for more information

M-200 Low Pressure Mix Head

Can handle up to three external recirculation valves at a flow rate up to 20 lb/min.

Click here for more information

Filler Fed Mix Head (FFH)

Incorporate a wide range of solid fillers directly into multi-component liquid systems

Click here for more information