Model FC-100
The new ESCO bun crusher is 100” wide and uses a 20HP motor with chain drive on both sides to give 20,000 lbs of crushing force. This allows a 60” high block to be compressed to just 4 inches.
The bun crusher can be integrated into an automated cutting line allowing 50’-100’ long buns to be conveyor fed to the crusher, crushed and then fed automatically to the ESCO blocking saw to cut blocks to the desired width and length, removing the outer skins.
Frame
Heavy-duty wall structural channel reinforced with steel mechanical tubing weldment.
Lower Carriage
Heavy-duty weldment in fixed position containing six powered rollers each 10 inches (0.254 m) in diameter by 100 inches
(2.54 m) long.
Upper Carriage
Same as lower carriage except pivoted via a hydraulic cylinder. Includes protractor dial to assist setting gap.
Roller Drive
20 HP variable speed drive.
Hydraulic Unit
Self contained, 2500 psi capacity, with reservoir.
Crushing Force
Approximately 20,000 lbs (6,800 kg) evenly distributed across width.
Gap
8 inches (203 mm) minimum to 34 inches (864 mm) maximum via pushbutton control.
Charge Height From Floor
34.5 inches (876 mm)
Discharge Height From Floor
24 inches (610 mm)
Roll Speed
Variable, 10 - 25 FPM (3 - 7.6 m/min)
Controls
Nema 12 frame mounted enclosure including all necessary operator controls for variable roll speed, hydraulic power unit,
and upper carriage raise and lower. Includes emergency stop button on both sides of the machine.
Power Requirement
480 Volt, 60 Cycle, 3 Phase @ 30 amps.
|
