ESCO Software & Technology

ESCODraw Pro Advanced Drawing and Nesting

ESCO Draw gives you the flexibility to do what you want with your parts. We have combined leading technology in a simplified format to give you the ability to create parts, optimally nest them on a sheet, and manage your parts from creation to cutting.

ESCO Draw gives you all the options you need to plan for your cutting. We allow you to draw your parts, rotate them, mirror them, create arrays, and much more all through our main ESCO Draw form.

Cutting Foamglas® with ESCODraw

We've taken the time over the last 3-4 years to fine tune our horizontal wire saw to make it easier to cut through Foamglas®. Let's take a moment to learn about the saw.

Contact Us
For more information :
616-453-5458

Para Español :
616-453-5458 ext. 217

Fax :
616-453-6227

Email :
info@edge-sweets.com

contact us
Custom Engineered Foam Cutting Lines

ESCODraw Pro - Advanced Drawing and Nesting Software

ESCO Draw gives you the flexibility to do what you want with your parts. We have combined leading technology in a simplified format to give you the ability to create parts, optimally nest them on a sheet, and manage your parts from creation to cutting.

ESCO Draw gives you all the options you need to plan for your cutting. We allow you to draw your parts, rotate them, mirror them, create arrays, and much more all through our main ESCO Draw form.

Read More
Custom Engineered Polyurethane Dispensing

ESCODraw Pro - Cutting Foamglas®

At first glance this seems simple, right? Plug in the values you want, and let it cut. However, because of the rigidness of the Foamglas®, if you're cutting on a horizontal wire saw like the PM III, gravity will always be an issue.

Once you've cut through the top row of insulation, the parts you've just cut are typically going to fall. This means that if you spaced your parts close together to try and get more yield out of your bun, your next pass through is likely going to graze the bottom of the first row. The best way to solve this issue is to make sure you leave at least a part clearance of at least 3 times your wire diameter to ensure that any falling parts are not going to be cut again.

Read More