Model 10
The Model 10 series is a two-wheel horizontal saw
for slitting sheets up to 12” (305mm) thick. The machine is available with a powered table or conveyor movement
system and can be built as a basic model with a standard control system or with a PLC when the highest accuracy is required.
Table
The standard table length is 11' (3353mm) with wood top coated in Ferrox™. Table rails are steel tubing and wheels have sealed bearings with nylon tires. The table traverses manually with a speed of 0 to 100 FPM. Drive is DC SCR 3/4 HP. Has automatic sequencing.
Blade - Blade Guide - Blade Wheels
- Typically uses a serrated saber tooth blade, but can use a saw-tooth or knife blades. The blade sharpener should be included when cutting with the
knife blade to ensure longer life and optimum cutting performance.
- Indexing thickness is 0.001”.
- Standard cutting head blades run on 14” (355mm) diameter wheels that feature a molded urethane elastomer
coating.
- Standard blade is 1” (25mm) wide x 0.02” (0.5mm) thick.
- Blade motor is 5HP and allows the blade to run at a no load speed of 4200FPM (1280m/min).
- A Teflon coated blade guide 0.084” (2mm) x 3.125” (79mm) wide, die spring tensioned, is supplied with each
machine. This can be upgraded to a heavy duty Teflon guide 0.314” (8mm) x 3.125” (79mm) wide or blade guide
stabilizer if the material being cut requires additional support.
- Tilt of 0 to 5 degrees.
- Air positioned blade sharpener using long life Borazon (TM) wheels is supplied as standard.
- 14" diameter blade wheels with steel tire surface and aluminum ball type bearings.
Optional Features
- 9' (2743mm) long table
- Variable speed powered table fully automatic operation; forward speed 0 to 100 ft/minute (30 m/minute); reverse speed constant or variable
- Blade sharpener
- Pressure roll assembly
- Heavy duty guide for foams under .0375 thickness
- Conveyor with speed range of up to 150 FPM
- Raise cutting height from 36" (914mm) to 48" (1219mm)
- Vacuum table assembly with 16" chamber, centered under blade, 10 HP motor
- Left side of the head with powered tilt up to 12 degrees (Model 10-72 only)
Specifications
|
10-36 |
10-48 |
10-72 |
10-84 |
Throat capacity – stack height below blade |
12” (305mm) |
12” (305mm) |
12” (305mm) |
12” (305mm) |
Maximum blade height above table |
36” (914mm) |
36” (914mm) |
36” (914mm) |
36” (914mm) |
Cutting width |
36” (914mm) |
48” (1219mm) |
72” (1829mm) |
84” (2134mm) |
| Floor Space Required: |
| Width |
92" (2286mm) |
104" (2642mm) |
126” (3200mm) |
|
| Height |
90" (2286mm) |
90" (2286mm) |
90" (2286mm) |
|
| Length |
240" (6096mm) |
240" (6096mm) |
240" (6096mm) |
240" (6096mm) |
|
